LED Autolamps Multivolt 81 Series Trailer Stop Tail Indicator Light
Our Part No. LU31081M
Manufacturer’s Part No. 81STIM
This advert is for 1x LED Autolamps Multivolt 81 Series Trailer Stop Tail Indicator Light
This light is 81mm x 81mm square and have a width of 24mm
Additionally, there is approximately 300mm of cable on the back of the light for wiring
Not only does it have a hardened plastic lens, but also is shock, dust and waterproof
It also has a signature diamond pattern on the lens
Fully sealed circuit as well as hardened acrylic lens
With it’s extremely compact design, the light can be discreetly added to the back of any trailer, kit car as well as lorries and other commercial vehicles
Multivolt – Can run off 12 volt systems as well as 24 volt.
All LED Autolamps lights are EC and EMC approved.
Also suitable for use on roads in the UK and Europe.
IP67 rated and therefore will operate submerged 1m below water for 30 minutes (ideal for boat trailers).
5 year warranty
Please Note – LED lamps are not compatible with some modern fault checking systems fitted to vehicles.
IP67 rating is for the lamp only water can run up cables into the light and invalidate the warranty if the connection is not suitably isolated. We recommend using heat shrink to cover joints in cables.
To view our full range of 12 Volt 81 Series light, please follow the links below;
81F 12 Volt Fog Light
81R 12 Volt Stop/Tail Light
81A 12 Volt Indicator Light
81W 12 Volt Reverse Light
81STI 12 Volt Stop Tail Indicator Light
Please note: LED Lights are not compatible with some Plug-in systems on later cars. They do however work fine with later cars fitted with bypass relays although the indicator buzzer does not always work. for more information click here
LED Autolamps Multivolt 81 Series Trailer Stop Tail Indicator Light Specifications-
|Stop||6 Led’s||0.22Amps @ 13.8 V / 0.12Amps @ 28V|
|Tail||6 Led’s||0.01Amps @ 13.8 V / 0.01Amps @ 28V|
|Indicator||6 Led’s||0.19Amps @ 13.8 V / 0.09Amps @ 28V|
|Connection type||300mm Hardwired cable|
|Fixing type||2x mounting holes on 50mm centers|
|EC approved||Yes||Documents available|
As these lights come with wires out of the back. You will need to join the wires to another wire with a RED inline crimp connector. We do recommend using heat shrink connectors on these lamps as this will seal the joint and stop water getting in and corroding the wires.